1. Click File> New> Click Part> O.K.
2. Click Tools> Option> Select document properties tab. Select Units> under Unit System select IPS (Inch, Pound, Seconds)> O.K.
3. Select TOP plane, from lower left menu select Normal to.
4. Click Sketch in command Manager, Click circle. As you can see on upper right corner sketch icon appear indicate that you are on sketch mode.
5. Pick origin point as string point, drag to right hand side
No need to be exact the size will define in later step. Press keyboard key ESC to end circle sketch.
NOTE: IN the sketching you see two lines, 1. Black Line 2. Blue Line.
1. Black Line: It means your sketch is fully defined/constrained
2. Blue Line: It means your sketch under define or not not fully constrained. It means your sketch dimension can be changed by dragging your sketch.
7. Change display to Isometric View.
8. Insert coil> Click Insert> Cirve> Helix/Spiral
9. Press F to zoom fit, set parameters constant pitch, pitch 0.1 inch in revolution 4.
Start angle 0 degree and
select clockwise > O,K.
10. Click on right plane> click Normal To.
11. Click Sketch> Click Circle. Sketch circle at start point, then click smart dimension set circle diameter to 0.05 inch.
12. Click exit sketch. click features and activate features menu. Click swept boss/base and set profile to sketch2 by click on circle sketch and set path by click helix path and O.K.
13. Change display to Isometric View.
14. Press F to zoom fit.
Done.
2. Click Tools> Option> Select document properties tab. Select Units> under Unit System select IPS (Inch, Pound, Seconds)> O.K.
3. Select TOP plane, from lower left menu select Normal to.
4. Click Sketch in command Manager, Click circle. As you can see on upper right corner sketch icon appear indicate that you are on sketch mode.
5. Pick origin point as string point, drag to right hand side
No need to be exact the size will define in later step. Press keyboard key ESC to end circle sketch.
NOTE: IN the sketching you see two lines, 1. Black Line 2. Blue Line.
1. Black Line: It means your sketch is fully defined/constrained
2. Blue Line: It means your sketch under define or not not fully constrained. It means your sketch dimension can be changed by dragging your sketch.
7. Change display to Isometric View.
8. Insert coil> Click Insert> Cirve> Helix/Spiral
9. Press F to zoom fit, set parameters constant pitch, pitch 0.1 inch in revolution 4.
Start angle 0 degree and
select clockwise > O,K.
10. Click on right plane> click Normal To.
11. Click Sketch> Click Circle. Sketch circle at start point, then click smart dimension set circle diameter to 0.05 inch.
12. Click exit sketch. click features and activate features menu. Click swept boss/base and set profile to sketch2 by click on circle sketch and set path by click helix path and O.K.
13. Change display to Isometric View.
14. Press F to zoom fit.
Done.
